Construction Site Injuries: Are You Covered?

Aylin Poulton | Whirlwind Steel Buildings & Components | April 5, 2016 For 2014, OSHA reported that there were 4,251 worker fatalities in private industry. Of those, 874 were in construction. In short, one in five workers who died on the job in 2014 worked in construction. That is nearly 17 deaths per week or… Continue reading Construction Site Injuries: Are You Covered?

OSHA’s New Regulation on Confined Spaces in Construction

Conor H. Meeks | Taft Stettinius & Hollister LLP | October 28, 2015 On May 4, 2015, the Occupational Safety and Health Administration (OSHA) issued a new regulation on confined spaces in the construction industry. Previously, there was only one rule for construction employers — provide training to employees who enter confined spaces. The new regulation (29… Continue reading OSHA’s New Regulation on Confined Spaces in Construction

Cal / OSHA Wins Unprecedented Decision in Case Protecting Workers from Indoor Heat

November 2, 2015 The California Occupational Safety and Health Appeals Board (Appeals Board) has ruled in favor of Cal / OSHA’s 2012 citations against two employers because their Injury and Illness Prevention Programs (IIPP) failed to effectively address the hazard of indoor heat. “This is the first case of indoor heat considered by the Appeals Board.… Continue reading Cal / OSHA Wins Unprecedented Decision in Case Protecting Workers from Indoor Heat

Published
Categorized as Uncategorized Tagged ,

Fall Hazards Due to Construction Issues

Advise & Consult, Inc. | October 26, 2015 What are Fall Hazards? ‘Fall hazards’ is a pretty self explanatory term in itself. The hazards or perils of a fall are common on construction sites and most of the workers are exposed to them on a daily basis as they work to earn their livelihood. A… Continue reading Fall Hazards Due to Construction Issues

Fall Protection Trigger Height May Change in Oregon

The change from 10 to 6 feet would be effective Jan. 1, 2017. Also, slide guards could no longer be used as a primary fall protection system as of Oct. 1, 2017. Oregon State’s OSHA is considering a change in the minimum height for general fall protection to 6 feet from 10 feet.  If this… Continue reading Fall Protection Trigger Height May Change in Oregon

%d bloggers like this: